Enhance your Raspberry Pi 4 with Quad SATA Expansion Kit

Description

QUAD SATA HAT KIT for your Raspberry Pi 4
Easily build your own NAS / Media-server based on Raspberry Pi 4
Description
Mount up to 4x 2.5″ HDD or SSD (max height 9.5mm)
Software RAID 0/1/5
HDD/SSD status LED online/activity/fault
Utilizes two independent USB3 buses on Raspberry Pi 4
DC Type (5.5/2.5) power input with support for 2.5inch drives and Raspberry Pi 4
HDD suspend mode supported
UASP support
Capacity up to 16TB (e. g. 4x 4TB SSD)
PWM controlled fan for HDD heat dispatching
OLED display for IP Address/Storage info
Does only work with Raspberry Pi 4
Easy to set up and run
Size (L/W/H) 94 x 70 x 173 mm
Product Content
Quad SATA HAT board
SATA HAT Top board, management board including OLED status display and active cooling
HAT connector cable
EcoPI Quad Sata case (aluminum)
USB3.0 dual bus connector
Heat sink kit with PWM fan for Raspberry Pi 4
What is so special?
Smaller than a bottle of Coke
Fits into the smallest book shelf
Low noise PWM fans
High capacity up to 16TB
Economic as surveillance system
Fast as media server
Backup server for your home
OLED display for basic status information
Nice lean design
IMPORTANT:
You need to use a >=40W 12V DC Power supply to run this NAS!
Raspberry Pi 4 2/4GB is recommended
Just add your Raspberry Pi 4 to this Kit and your NAS is complete and it really looks great!